- 1 How do you turn off the alarm on a weather station?
- 2 Why is my La Crosse Weather Station beeping?
- 3 How do you turn off the alarm on an atomic clock?
- 4 Why is my weather station beeping?
- 5 Why does my atomic clock keep beeping?
- 6 How do you reset a lacrosse rain gauge?
- 7 How do I set the time zone on my LaCrosse atomic clock?
- 8 How do you set the LaCrosse atomic clock?
- 9 How long does it take for an atomic clock to set itself?
- 10 How do you set an alarm on an atomic clock?
- 11 How do you change the time on an atomic clock?
How do you turn off the alarm on a weather station?
NOTE: To disable ALL alarms at once, press and HOLD the “ ” button for 10 seconds. You will automatically exit alarm SET MODE if no buttons are pressed for 10 seconds.
Why is my La Crosse Weather Station beeping?
Answer: It probably needs new batteries or maybe the alarm is set to on. The instructions will explain how to check the alarm status and change the batteries. If that doesn’t work, return it as defective.
How do you turn off the alarm on an atomic clock?
the w ords “ALARM ON” appear on the clock To Turn Alarm off: Press and release the “ALARM ON/OFF” button.
Why is my weather station beeping?
The flashing of the lights and occasional beeping of the unit is typically caused when the radio has not received a Required Weekly Test (RWT) for more than ten days.
Why does my atomic clock keep beeping?
NOTE: After the setting process has been completed, the clock should start to beep. NOTE: Due to solar radiation in the atmosphere, the atomic clock signal is weaker during the day. Most synchronization with the WWVB atomic clock signal happens at night when there is less interference.
How do you reset a lacrosse rain gauge?
Reset Rainfall Readings
- Press the RAIN button to view individual rain readings.
- Hold the MINUS button for five seconds to reset the individual value.
- Rainfall reading will reset to 0.00.
How do I set the time zone on my LaCrosse atomic clock?
- Hold down the “SET” button for 2 seconds, the default setting “-5EST” will flash in the Date LCD.
- Press and release the “+” button to select the appropriate time zone.
- Press and release the “SET” button to confirm the time zone setting, and to advance to DST (Daylight saving time) setting.
How do you set the LaCrosse atomic clock?
Press and hold the SET button for 3+ seconds to activate the manual mode. Once the clock is in manual mode, there are two ways to move the minute hand forward. 2. Hold the SET button down to move the minute hand forward consistently.
How long does it take for an atomic clock to set itself?
When you turn a radio controlled clock on, it will probably miss the first time code, so it usually takes more than one minute to set itself (sometimes 5 minutes or longer) depending on the signal quality and the receiver design.
How do you set an alarm on an atomic clock?
To set the alarm time, press AND HOLD the “ALARM” button on the side of the alarm clock until the HOUR flashes to enter into alarm time set mode.
How do you change the time on an atomic clock?
Atomic Clocks may also be set manually and be very accurate. Simply insert the battery, press your time zone and then press the flap just above the left side of the battery. Hold until you reach the correct time and then release.